Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
- 11. A suspension bracket
   11.1. Specifications
   11.2. The bottom lever of a forward suspension bracket
   11.3. Replacement of the plug of the bottom lever
   11.4. Plug replacement (G) the bottom lever
   11.5. The forward stabilizer of cross-section stability
   11.6. A rack of a back suspension bracket
   11.7. Replacement of the plug of the back longitudinal lever of a back suspension bracket
   11.8. Replacement of the plug of the back cross-section lever (And and) a back suspension bracket
   11.9. The back stabilizer of cross-section stability
   11.10. Corners of installation of forward wheels
   11.11. Adjustment of a convergence of back wheels
   11.12. Deterioration of tyres
   11.13. Chains противоскольжения
   11.14. Wheel palpation
   11.15. A tightening of nuts of fastening of a wheel
   11.16. Shift of wheels
   11.17. Check of withdrawal and course instability of the car
   11.18. Care of disks from an aluminium alloy
   11.19. Search and elimination of malfunctions
   11.20. Diagnostics of deterioration of tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes







11.5. The forward stabilizer of cross-section stability

Removal

PERFORMANCE ORDER
1. Remove a forward wheel.
2. Remove draught of the stabilizer.
3. Remove an arm of the stabilizer and the plug
4. Remove a back support of the engine.
5. Remove the stabilizer of cross-section stability.

Check

PERFORMANCE ORDER
1. Check up the stabilizer of cross-section stability on absence of loss of elasticity and damages.
2. Check up a condition of all bolts.
3. Check up a protective cover of draught of the stabilizer on absence of cracks or damages.
4. Check up twisting moment which it is necessary to put for проворачивания pins of the spherical hinge of draught of the stabilizer.

If there are cracks in a protective cover, replace it and add greasing in the hinge.

Some times shake here and there a pin of the spherical hinge of draught of the stabilizer.

The twisting moment: 1,7–3,2 Н•м

If the twisting moment exceeds admissible values, replace draught of the stabilizer.

If the twisting moment considerably below admissible value, the spherical hinge can repeatedly be used, if it is not got jammed and has no excessive люфта.


Installation

PERFORMANCE ORDER
1. Establish the plug on the stabilizer of cross-section stability.
2. Level an arm in relation to the plug. Be convinced, that the arm reliably covers the plug.
3. Temporarily fix an arm of the plug and establish the plug on the second party of the stabilizer.
4. Fix draught of the stabilizer a wrench with an open pharynx on 14 mm and screw самоконтрящуюся a nut.