Hyundai Accent

Repair and car operation


Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
- 15. A central air
   15.1. Specifications
   15.2. The instruction on coolant application
   15.3. Remarks at replacement of elements of a central air of air
   15.4. Connection of elements of a central air of air
   15.5. Check of elements of the central air established on the car
   15.6. Installation of manometres for pressure measurement
   15.7. Откачка atmospheric air from a central air
   15.8. Gymnastics of a central air of air
   15.9. Check of level of a coolant
   15.10. Check of operational characteristics
   15.11. Oil for greasing of the compressor of the conditioner
   15.12. Relay check
   15.13. The conditioner compressor
   15.14. The plug of coupling and a pulley of the compressor of the conditioner
   15.15. The coil of excitation of coupling
   15.16. Compressor check on the car
   15.17. The gauge of threefold (double) pressure
   15.18. The fan and the condenser
   15.19. The evaporator
   15.20. Check of the thermostatic gauge (термистора)
   15.21. The air filter of the evaporator
   15.22. The heating and ventilation block
   15.23. The heater block
   15.24. The fan
   15.25. Search and elimination of malfunctions
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes



15.2. The instruction on coolant application
PERFORMANCE ORDER
1. Liquid coolant R–134a with the high maintenance of flying substances. Its hit on a skin can end обморожением, therefore at work with a coolant it is necessary to dress protective gloves.
2. As standard measures of protection at work with a coolant it is necessary to use points for protection of eyes. At coolant hit on clothes or protective means immediately wash out the amazed place a water considerable quantity.
3. Liquid coolant R–134a is stored in containers (cylinders). Store a cylinder with a coolant at temperature no more 52°C.
4. For check of tightness of a central air use the electronic gauge. Keep in mind, that coolant R–134a after contact to a flame decays with allocation of very poisonous gas.
5. Use only the recommended oil for greasing of elements of a central air of air as, otherwise, the system can fail.
6. Greasing PAG intensively absorbs a moisture from atmospheric air, therefore it is necessary to observe following precautions:

– At separation of components of a central air of air immediately close connections by corresponding covers for an exception of hit of a moisture in system;
– At installation of new components of a central air of air remove from them protective covers directly ahead of their installation;
– Connect tubes and hoses of a central air of air as soon as possible to reduce hit in moisture system;
– Use greasing for air central air only from the tight container.
7. If there was a casual discharge of a central air of air, before system service air a workplace.