Hyundai Accent

Repair and car operation


Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
- 15. A central air
   15.1. Specifications
   15.2. The instruction on coolant application
   15.3. Remarks at replacement of elements of a central air of air
   15.4. Connection of elements of a central air of air
   15.5. Check of elements of the central air established on the car
   15.6. Installation of manometres for pressure measurement
   15.7. Откачка atmospheric air from a central air
   15.8. Gymnastics of a central air of air
   15.9. Check of level of a coolant
   15.10. Check of operational characteristics
   15.11. Oil for greasing of the compressor of the conditioner
   15.12. Relay check
   15.13. The conditioner compressor
   15.14. The plug of coupling and a pulley of the compressor of the conditioner
   15.15. The coil of excitation of coupling
   15.16. Compressor check on the car
   15.17. The gauge of threefold (double) pressure
   15.18. The fan and the condenser
   15.19. The evaporator
   15.20. Check of the thermostatic gauge (термистора)
   15.21. The air filter of the evaporator
   15.22. The heating and ventilation block
   15.23. The heater block
   15.24. The fan
   15.25. Search and elimination of malfunctions
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes



15.24. The fan
1 – a tube of cooling of the electric motor of the fan;
2 – the block of resistors;
3 – an air inlet;
4 – a shaft заслонки an air inlet; 		5 – the top case of the fan;
6 – the bottom case of the fan;
7 – крыльчатка the fan;
8 – the fan electric motor;
9 – a cover of the electric motor of the fan.

Removal and installation
PERFORMANCE ORDER
1. Remove the panel of devices.
2. Disconnect sockets from the electric motor of the fan and the block of resistors.
3. Turn out nuts and remove the evaporator block.
4. Turn out 3 nuts (or bolts) fastenings of an arm of the fan.
5. Remove the fan block.
6. Installation is spent to sequences, return to removal.

Removal
PERFORMANCE ORDER
1. Disconnect a tube of cooling of the electric motor of the fan.
2. Turn out three screws and remove the fan engine.
3. Release clamps, крепящие an air inlet to the top case of the fan.
4. Remove an air inlet.
5. An edge of a flat screw-driver release six clamps and divide the top and bottom cases of the fan.
6. Turn out two screws and remove the fan resistor.
7. Assemblage is spent in sequence, return dismantling.

Check of the engine of the fan

PERFORMANCE ORDER
Additional wires submit pressure from the storage battery to contacts and a socket of the engine of the fan. If the fan engine rotates, means, it is serviceable.