Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
- 2. The engine
   - 2.1. Engines SOHC
      2.1.1. Specifications
      2.1.2. A gear belt
      2.1.3. Check of a tension of a gear belt
      2.1.4. Adjustment of a tension of a gear belt
      2.1.5. Поликлиновой a belt
      2.1.6. Engine support
      2.1.7. A forward cover and the oil pump
      2.1.8. The air filter (ACL)
      2.1.9. A head of cylinders
      2.1.10. Коромысла
      2.1.11. Hydraulic jacks of backlashes of valves
      2.1.12. Replacement of a saddle of the valve
      2.1.13. Replacement of the directing plug of the valve
      2.1.14. The valve
      2.1.15. A camshaft
      2.1.16. Rods
      2.1.17. A cranked shaft
      2.1.18. A flywheel
      2.1.19. A piston finger
      2.1.20. A final collector
      2.1.21. An inlet collector and the air chamber
      2.1.22. The block of cylinders
      2.1.23. Removal and engine and transmission installation
      2.1.24. System of release of the fulfilled gases
      2.1.25. Search and elimination of malfunctions
   + 2.2. Engines DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes







2.1.13. Replacement of the directing plug of the valve

The directing plug of the valve is established by means of a press. Using the adaptation for installation of the directing plug of the valve 09221-22000 or the suitable tool, replace directing plug as follows.

PERFORMANCE ORDER
1. Using the adaptation for installation of the directing plug of the valve, выпрессуйте the plug of the valve from a head of cylinders in a direction to the block of cylinders.
2. Put to an aperture of a head of cylinders the new directing plug of the valve of the increased repair size.
3. The adaptation for installation of the directing plug of the valve 09221-22000 запрессуйте the plug in a head of cylinders. The adaptation provides запрессовку plugs on strictly certain depth. Measure выступание the top part of the directing plug of the valve from a head of cylinders. Pay attention, that выступание the directing plug of the valve variously for inlet (47,2 mm) and final (39,1 mm) valves.
4. After запрессовки directing plugs of valves insert new valves and check up a backlash.
5. Each time at replacement of directing plugs of valves check up and, if necessary, replace saddles of valves.