Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. A transmission
   + 9.1. A mechanical transmission
   - 9.2. An automatic transmission
      9.2.1. Specifications
      9.2.2. A control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Pressure check трансмиссионной liquids
      9.2.6. Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
      9.2.7. Check of level of a liquid in an automatic transmission
      9.2.8. Check of work of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a hill-climbing gear
      9.2.11. Pressure adjustment in a highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. The selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes




9.2.9. Adjustment of the switch of indication of position of the lever of the selector

PERFORMANCE ORDER
1. Move the selector lever to position N.
2. Ослабьте a control lever counternut in a cable and lever junction.
3. Move a control lever to position N.
4. Turn the case of the switch of indication of position of the lever of the selector on distance to 12 mm and combine the wide end of a control lever with a switch ledge.
5. Tighten bolts of fastening of the switch the moment of an inhaling 10–12 Н•м.

The prevention

At turn of the case of the switch be careful not to damage a sealing ring.


6. Check up, that the selector lever is in position N.
7. Adjust nut position so that there was no sagging of a cable and the selector lever moved smoothly.
8. Make a control trip and be convinced, that the transmission is established in the position corresponding to each position of the lever of the selector.