| 1. Establish the universal hinge on a shaft of a gear wheel of steering transfer. |
The prevention If the steering column is equipped by the mechanism of adjustment of a corner of an inclination, satisfy following conditions.
Default of these conditions can lead to deformation of an arm of a corner of an inclination therefore the lever of a corner of an inclination and a lever clamp can be damaged.
|
|
2. Before installation check up, that on an arm there is an aperture for a hairpin.
1) If it so, fix the lever of a corner of an inclination in neutral position and establish a hairpin stopper in an aperture, then separate the lever of a corner of an inclination. |
|
2) Otherwise, fix the lever of a corner of an inclination about neutral position. |
|
3. Screw a bolt, крепящий to a steering shaft an U-shaped element of the universal hinge. The inhaling moment: 15–20 Н•м
|
|
4. Temporarily screw two assembly bolts. |
| 5. Screw two assembly nuts. The inhaling moment: 13–18 Н•м
|
| 6. Tighten the demanded moment these inhalings two assembly bolts. |
|
7. If the hairpin stopper is established, move a steering column to the bottom position. |