+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
- 4. Cooling system
4.2. Check of tightness of system of cooling
4.3. Check of density of a cooling liquid
4.4. Поликлиновой a belt
4.5. Tubes and hoses of system of cooling
4.6. The water pump of engine SOHC
4.7. The water pump of engine DOHC
4.8. A radiator
4.9. A radiator cover
4.10. Engine SOHC thermostat
4.11. Engine DOHC thermostat
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes
без проституток и воров
|1 – a bolt, 15–20 Н•м;
2 – the gauge of temperature of a cooling liquid;
3 – a lining;
4 – a thermostat casing;
|5 – the thermostat;
6 – a lining;
7 – the union of an exit of a cooling liquid.
| PERFORMANCE ORDER
| 1. Merge cooling liquid to the level located below the thermostat.
|2. Remove the union of an exit of a cooling liquid and a lining.
|3. Remove the thermostat.
||4. On a thread suspend the thermostat in a transparent vessel with water. Insert into water the thermometer, heat up a vessel with water and observe of the thermostat valve. Define temperature of the beginning of opening and full opening of the valve of the thermostat.
Temperature of the beginning of opening of the valve of the thermostat: 82°С.
Temperature of full opening of the valve of the thermostat: 95 °С.
Course of the valve of the thermostat: 8,0 mm
| PERFORMANCE ORDER
| 1. Establish the thermostat so that the valve for air removal correctly settled down in a nest. If the thermostat is established in wrong position, its working capacity can be broken.
| 2. Establish a new lining and the union of an exit of a cooling liquid.
| 3. Fill in in cooling system necessary quantity of a demanded cooling liquid. Start up the engine and check up absence of leaks from cooling system.