Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
- 4. Cooling system
4.1. Specifications
4.2. Check of tightness of system of cooling
4.3. Check of density of a cooling liquid
4.4. Поликлиновой a belt
4.5. Tubes and hoses of system of cooling
4.6. The water pump of engine SOHC
4.7. The water pump of engine DOHC
4.8. A radiator
4.9. A radiator cover
4.10. Engine SOHC thermostat
4.11. Engine DOHC thermostat
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes
|
1 – a bolt, 8–10 Н•м;
2 – the water pump; |
3 – a lining;
4 – a bolt, 12–15 Н•м. |
Removal
| PERFORMANCE ORDER |
| 1. Disconnect a wire from the negative plug of the storage battery. Merge cooling liquid in the suitable container and disconnect a hose from the union of an exit of a cooling liquid from the water pump. |
| 2. Remove поликлиновой a belt and a pulley of the water pump. |
| 3. Remove casings of a gear belt and a roller of a tension of a gear belt. |
| 4. Turn out bolts of fastening of the water pump, then remove a generator support. |
| 5. Remove the water pump from the block of cylinders. |
|
Check
| PERFORMANCE ORDER |
| 1. Check up each detail on absence of cracks, damages or deterioration and if necessary replace the pump in gathering. |
| 2. Turn a shaft of the water pump and check up smoothness of rotation in the absence of noise. |
|
3. Check up absence of leaks of a cooling liquid from the pump. If there is a leak from an aperture And, pump consolidation is faulty. If necessary, replace the water pump. |
|
Installation
| PERFORMANCE ORDER |
|
|
1. Clear of the rests of a lining and an alien material a surface of consolidation of the water pump. |
| 2. Establish on the water pump a new lining, establish the pump and fix its bolts. The inhaling moment: 12–15 Н•м
|
| 3. Establish a roller of a tension of a gear belt and adjust a belt tension. |
| 4. Establish casings of a gear belt. |
| 5. Establish a pulley of the water pump and поликлиновой a belt, then adjust a belt tension. |
| 6. Fill in in cooling system necessary quantity of a demanded cooling liquid. |
|
7. Connect a wire to the negative plug of the storage battery. Start up the engine and check up absence of leaks from cooling system. |
|
|
|