Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
- 6. Fuel system
   6.1. Specifications (SOHC and DOHC)
   6.2. Check of the fuel pump
   6.3. Check of the pressure created by the fuel pump
   6.4. Checks of system of injection MFI
   6.5. A control lamp of malfunctions (MIL)
   6.6. Diagnostic codes of malfunctions ŤOBD-IIť
   6.7. Diagnostic codes of malfunctions, except ŤOBD-IIť
   6.8. Replacement of the fuel filter
   6.9. Replacement of the terminator of overflow (the double-thread valve)
   6.10. Replacement of the gauge of level of fuel
   6.11. A control system of engine MFI
   6.12. Fuel atomizers
   6.13. Throttle knot
   6.14. The power supply system with the carburettor
   6.15. Check of frequency of rotation of idling
   6.16. Adjustment of frequency of rotation of idling
   6.17. Frequency of rotation of idling and adjustment of a fuel mix
   6.18. Check and starting arrangement adjustment
   6.19. Check and adjustment of a free course of a cable of an accelerator
   6.20. A fuel tank
   6.21. The canister of catching of steams of fuel
   6.22. Replacement of the fuel filter
   6.23. The carburettor
   6.24. A cable and an accelerator pedal
   6.25. Search and elimination of malfunctions of fuel system with the carburettor
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes




6.12. Fuel atomizers

Elements of system of giving of fuel

1 – an inlet collector;
2 – a bolt, 15–20 Н•м;
3 – throttle knot;
4 – a bolt, 15–20 Н•м;
5 – a lining of throttle knot;
6 – a fuel highway;
7 – the air chamber.

Removal

PERFORMANCE ORDER
1. Before separation топливопроводов remove pressure in fuel system as, otherwise, the fuel which is under pressure, will intensively follow from fuel system.

The prevention

Close connection by a towel to exclude разбрызгивание the fuel, caused by residual pressure in топливопроводе.


2. Remove a fuel highway together with fuel atomizers.

The prevention

At removal of a fuel highway do not drop fuel atomizers.



Check

PERFORMANCE ORDER
1. Disconnect a socket from a fuel atomizer and measure resistance between socket contacts.

Resistance: 15,9ą 0,35 Ohm

2. If the resistance size differs from demanded value, replace a fuel atomizer.

Installation

PERFORMANCE ORDER
1. Establish on an atomizer new sealing rings.
2. Grease sealing rings of atomizers with fuel.
3. At installation of atomizers turn them round an axis in one and other parties.
4. Be convinced, that atomizers are densely inserted into a fuel highway.