Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
- 6. Fuel system
   6.1. Specifications (SOHC and DOHC)
   6.2. Check of the fuel pump
   6.3. Check of the pressure created by the fuel pump
   6.4. Checks of system of injection MFI
   6.5. A control lamp of malfunctions (MIL)
   6.6. Diagnostic codes of malfunctions ŤOBD-IIť
   6.7. Diagnostic codes of malfunctions, except ŤOBD-IIť
   6.8. Replacement of the fuel filter
   6.9. Replacement of the terminator of overflow (the double-thread valve)
   6.10. Replacement of the gauge of level of fuel
   6.11. A control system of engine MFI
   6.12. Fuel atomizers
   6.13. Throttle knot
   6.14. The power supply system with the carburettor
   6.15. Check of frequency of rotation of idling
   6.16. Adjustment of frequency of rotation of idling
   6.17. Frequency of rotation of idling and adjustment of a fuel mix
   6.18. Check and starting arrangement adjustment
   6.19. Check and adjustment of a free course of a cable of an accelerator
   6.20. A fuel tank
   6.21. The canister of catching of steams of fuel
   6.22. Replacement of the fuel filter
   6.23. The carburettor
   6.24. A cable and an accelerator pedal
   6.25. Search and elimination of malfunctions of fuel system with the carburettor
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes

With 123movies, you can enjoy uninterrupted viewing without ads.

6.16. Adjustment of frequency of rotation of idling

Adjustment conditions

Headlights, the electric fan of a radiator and all electric consumers should be switched off, and the transmission should be established in neutral position.

1. The engine should be прогрет to temperature of a cooling liquid 80–95°C.
2. No more than on 5 with increase frequency of rotation of a cranked shaft to 2000–3000мин–1.
3. Then allow to the engine to work idling within 2 minutes
4. On a tachometre define frequency of rotation of idling. If frequency of rotation differs from demanded, adjust it, rotating the adjusting screw of frequency of idling № SAS-1.

Do not rotate screw SAS-2 which defines люфт between throttle заслонкой and the lever, and it is precisely adjusted by car manufacture. If this adjustment is broken, adjustment of position throttle заслонки and starting arrangement adjustment cannot be executed precisely enough.