Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Antiblocking system of brakes (ABS)
   13.3. Prorolling of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of position of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Prorolling of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of a lay brake
   13.8. The vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. A pressure regulator
   13.11. A brake pedal
   13.12. Replacement of lobbies brake колодок
   13.13. A support of a forward brake
   13.14. The main brake cylinder
   13.15. Replacement brake колодок on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. A lay brake
   13.18. Hydraulic block HECU ABS
   13.19. The gauge of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes




13.17. A lay brake

1 – the lever of a lay brake;
2 – an adjusting nut;
3 – a cable of a lay brake.

Removal

PERFORMANCE ORDER
1. Remove the back console.
2. Turn away an adjusting nut and remove a cable of a lay brake.
3. Remove the switch of a lay brake.
4. Remove knot of the lever of a lay brake.
5. Remove a wheel.
6. Remove a brake drum.
7. Remove brake колодки.
8. Disconnect a cable of a lay brake from the lever on brake колодке.
9. Remove a clip, крепящий a cover of a cable of a lay brake to a brake board.
10. Remove a pillow of back sitting.
11. Ослабьте clips of fastening of a cable of a lay brake also remove it from the car.

Check

PERFORMANCE ORDER
1. Check up action of the switch of a lay brake.
2. Check up a ratchet of the lever of a lay brake on absence of deterioration.
3. Check up a cable of a lay brake on absence of deterioration or damages.

Installation

PERFORMANCE ORDER
1. Check up marks presence on the left and right cables of a lay brake and establish them on the places.
2. Move the lever of a lay brake on brake колодке completely back and establish springs.
3. Establish condensing rings in a direction shown in drawing.
4. Grease with the recommended greasing a ratchet and the doggie of a ratchet of the lever of a lay brake.

The recommended lubricant: SAE J310, NLGI №2

5. After jack installation adjust a course of the lever of a lay brake.