Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Antiblocking system of brakes (ABS)
   13.3. Prorolling of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of position of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Prorolling of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of a lay brake
   13.8. The vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. A pressure regulator
   13.11. A brake pedal
   13.12. Replacement of lobbies brake колодок
   13.13. A support of a forward brake
   13.14. The main brake cylinder
   13.15. Replacement brake колодок on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. A lay brake
   13.18. Hydraulic block HECU ABS
   13.19. The gauge of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes

13.3. Prorolling of hydraulic system of a drive of brakes with scanner use

Any hydraulic system works normally if air is removed from it.

1. Remove a cover from a compensatory tank with a brake liquid.

Recommended brake liquid: DOT3

The prevention

The brake liquid dissolves a paint, plastic and isolation of wires, therefore at casual hit of a liquid on a paint and varnish covering of the car or its components wash out their considerable quantity of water.
At prorolling under pressure do not press a brake pedal

2. Turn away a cover from the union of prorolling and attach to it one end of a transparent hose, and other end of a hose insert into the glass capacity of sufficient volume half filled with a brake liquid.
3. Connect the scanner to the diagnostic socket located under the panel of devices.
4. According to the scanner maintenance instruction choose the corresponding parametre.

The prevention

Consider maximum working hours of work ABS at work with the scanner to exclude перегорание the pump electric motor.

1) Establish firm of the manufacturer of the car.

2) Establish the car name.
3) Establish a mode of check of antiblocking system of brakes
4) Establish a way of removal of air.
5) Press "YES" to involve the pump with the electric motor and the electromagnetic valve.
6) Wait 60 with before operation of removal of air as, otherwise, it is possible to damage the electric motor.
5. Slowly press a brake pedal some times. At the pressed pedal of a brake a key ослабьте the union of prorolling also wait, the brake liquid without air vials yet will not start to leave. Tighten the union of prorolling and release a brake pedal.
6. Repeat a step 5 for removal of air from brake mechanisms of other wheels.
7. Tighten the prorolling union.

The inhaling moment: 7–9 Н•м