Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Antiblocking system of brakes (ABS)
   13.3. Prorolling of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of position of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Prorolling of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of a lay brake
   13.8. The vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. A pressure regulator
   13.11. A brake pedal
   13.12. Replacement of lobbies brake колодок
   13.13. A support of a forward brake
   13.14. The main brake cylinder
   13.15. Replacement brake колодок on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. A lay brake
   13.18. Hydraulic block HECU ABS
   13.19. The gauge of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes

13.6. Prorolling of hydraulic system of a drive of brakes

1. Remove a cover from a compensatory tank with a brake liquid.

The prevention

The brake liquid dissolves a paint, plastic and isolation of wires, therefore at casual hit of a liquid on a paint and varnish covering of the car or its components wash out their considerable quantity of water.
At prorolling under pressure do not press a brake pedal

2. Turn away a cover from the union of prorolling and attach to it one end of a transparent hose, and other end of a hose insert into the glass capacity of sufficient volume half filled with a brake liquid.
3. Slowly press a brake pedal some times.
4. At the pressed pedal of a brake a key ослабьте the union of prorolling also let out air from hydraulic system. Tighten the union of prorolling and release a brake pedal.
5. Repeat operations 3 and 4 until there will be a brake liquid without air vials.
6. Tighten the prorolling union.

The inhaling moment: 7–9 Н•м

7. Air removal spend in the sequence shown in drawing.