Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Antiblocking system of brakes (ABS)
   13.3. Prorolling of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of position of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Prorolling of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of a lay brake
   13.8. The vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. A pressure regulator
   13.11. A brake pedal
   13.12. Replacement of lobbies brake колодок
   13.13. A support of a forward brake
   13.14. The main brake cylinder
   13.15. Replacement brake колодок on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. A lay brake
   13.18. Hydraulic block HECU ABS
   13.19. The gauge of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes

13.8. The vacuum amplifier of brakes

1 – a vacuum hose;
2 – a clip;
3 – a pin with a head and an aperture under шплинт;
4 – a nut, 8–12 Н•м;

5 – распорная a lining;
6 – a lining;
7 – the vacuum amplifier of brakes.

Removal

PERFORMANCE ORDER

1. Disconnect brake tubes from the main brake cylinder.
	2. Remove the main brake cylinder.
The prevention The brake liquid dissolves a paint, plastic and isolation of wires, therefore at casual hit of a liquid on a paint and varnish covering of the car or its components, wash out their considerable quantity of water.
3. Disconnect a vacuum hose from the vacuum amplifier of brakes.
4. In car salon remove spring шплинт, and remove a pin with a head and an aperture under шплинт.
5. Remove the switch of stoplights.
	6. Turn away four nuts of fastening of the vacuum amplifier of brakes.
7. Remove the vacuum amplifier of brakes.

Installation

PERFORMANCE ORDER

1. Establish the vacuum amplifier of brakes with a new lining on a partition of a motor compartment and fix four nuts. The inhaling moment: 8–12 Н•м
2. Connect draught to a pedal of a brake and establish a pin with a head and an aperture under шплинт and fix its new spring шплинтом.
3. Establish the main brake cylinder on the vacuum amplifier of brakes and fix nuts.
4. From a motor compartment attach a vacuum hose to the vacuum amplifier of brakes.
5. Connect brake tubes and tighten connecting nuts of fastening of tubes.
6. Fill пополнительный a tank of brake system with a brake liquid. Remove air from a hydraulic contour of brake system.
7. Check up absence of leaks of a brake liquid.
8. Check up and, if necessary, adjust height of installation of a pedal and a free course of a pedal of a brake.
	9. After installation put greasing on points of contact of a pedal of a brake and draught.

home