Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
- 16. The electric equipment
   16.1. Specifications
   16.2. Electric chains
   16.3. Gymnastics system
   16.4. Check of an electric chain of gymnastics
   16.5. Power failure check on a wire connecting the storage battery with the generator
   16.6. Check of the current developed by the generator
   16.7. Check of developed pressure
   16.8. The generator
   16.9. The storage battery
   16.10. Check of relative density of electrolit
   16.11. Gymnastics of the storage battery
   16.12. Survey of the storage battery
   16.13. Start system
   16.14. A starter
   16.15. Check and replacement of elements статора
   16.16. The switch of blocking of ignition
   16.17. Check of the relay of a starter
   16.18. Check of the switch of blocking of ignition
   16.19. A radio receiver
   16.20. Dynamics
   16.21. The aerial
   16.22. The multipurpose switch
   16.23. A sound signal
   16.24. Safety locks
   16.25. A combination of devices
   16.26. The engine of a screen wiper of a windscreen
   16.27. Replacement of a headlight and the forward index of turn
   16.28. Adjustment of light of headlights
+ 17. The appendix
+ 18. Electroschemes




16.24. Safety locks

Safety locks serve to break off a chain, when force of a current will reach certain value to protect elements and wires which can be damaged too strong current. The sharp increase in force of a current is usually caused by malfunction in a chain, more often short circuit.

Designations of the chains protected by safety locks, are specified on a cover of the block of safety locks.

Before safety lock removal switch off a corresponding chain (or ignition), then get a safety lock from contacts. In a safety lock the wire should be visible; if the safety lock has fused, the wire will be torn or fused.


Always use safety locks of demanded capacity. Never use a safety lock of other capacity and do not replace it with something another.


Do not replace a safety lock more than once, not having eliminated a malfunction source. The current protected by a safety lock, is specified from above on a safety lock: pay attention, that safety locks have various colours for simplification of identification.

If the safety lock fuses right after replacements, do not replace it again, yet do not establish, and do not eliminate a cause of defect. In most cases a cause of defect is the short circuit caused by bad isolation. If the safety lock protects some chains, try to find a chain because of which fuses a safety lock, including each of chains by turns (if it is possible). Always have in the car the complete set of spare safety locks of various capacity. They should be fixed at the basis of the block of safety locks.

The electric chains protected by safety locks, located in a motor compartment


Contour
Current, And
The generator
100
ЕСМ
20
Стеклоподъемники
30
Конденсор
20
The storage battery
50
Lamps
20
Radiator
20
ABS
30
ABS
20
Ignition
30
The fan
30