Hyundai Accent

Repair and car operation



Hyundai Accent
- 1. The maintenance instruction
   1.1. The general data on the car
   1.2. Keys
   1.3. An immobilizer (anticreeping system of blocking of start of the engine)
   1.4. Anticreeping system
   1.5. Locks of doors
   1.6. A children's safety lock of a back door
   1.7. Forward seats
   1.8. Стеклоподъемники
   1.9. System of the centralised management of locks of doors
   1.10. Safety measures at using seat belts
   1.11. Care of seat belts
   1.12. Fastenings of seat belts of forward seats regulated on height
   1.13. A three-dot seat belt of the driver with the inertial mechanism of blocking
   1.14. A seat belt with fastening in two points (the central seat belt of back sitting)
   1.15. Children's seats
   1.16. Inflatable pillows of safety
   1.17. The panel of devices and контрольно measuring devices
   1.18. The index of level of fuel
   1.19. The index of temperature of a cooling liquid
   1.20. A speedometer
   1.21. Одометр (the counter of the passed way)
   1.22. The counter of daily run
   1.23. A tachometre
   1.24. The combined switch of light of headlights and turn indexes
   1.25. The switch of a cleaner and a windscreen washer
   1.26. A cleaner and a washer of back glass
   1.27. The proof-reader of light of headlights
   1.28. The emergency light alarm system
   1.29. A heater of back glass
   1.30. The switch of forward antifog headlights
   1.31. The switch of back antifog light
   1.32. Electronic clock
   1.33. Прикуриватель
   1.34. A forward ashtray
   1.35. A back ashtray
   1.36. A coaster
   1.37. Sun-protection шторка
   1.38. The hatch
   1.39. A lamp of illumination of salon
   1.40. A ware box
   1.41. External rear-view mirrors
   1.42. A heater of external rear-view mirrors
   1.43. Folding of external rear-view mirrors
   1.44. An internal rear-view mirror
   1.45. A lay brake
   1.46. Folding of backs of seats
   1.47. A back door / a luggage carrier cover
   1.48. Emergency opening of the lock of a cover of a luggage carrier
   1.49. Remote opening of the lock of a back door / of a cover of a luggage carrier
   1.50. Remote opening of a cover of a bulk mouth of a fuel tank
   1.51. Cowl opening
   1.52. Противосолнечный a peak
   1.53. Adjustment of height of installation of a steering wheel
   1.54. A sound signal
   1.55. Heating and ventilation system
   1.56. A cleaner of air for the evaporator and the fan
   1.57. A stereosystem
   1.58. The aerial
   1.59. Car driving
   1.60. The ignition lock
   1.61. Start-up of the engine of cars with the carburettor engine
   1.62. A mechanical transmission
   1.63. An automatic transmission
   1.64. Antiblocking system of brakes
   1.65. Economic driving
   1.66. Smooth passage of turns
   1.67. Movement in winter conditions
   1.68. Trailer or car towage
   1.69. The engine is not started
   1.70. If the engine is normally scrolled by a starter, but not started
   1.71. If the engine has decayed during movement
   1.72. Start-up of the engine from the storage battery of other car
   1.73. If the engine has overheated
   1.74. Car towage
   1.75. Emergency towage
   1.76. Prevention of corrosion and periodic leaving
   1.77. Identification number of the car (VIN)
   1.78. Car technical characteristics
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes




1.62. A mechanical transmission

Position of the lever of a gear change is traditional for five transfers of a forward course as it is represented in drawing.

Positions of the lever of a gear change

The prevention

At inclusion of transfer of a backing, after a full stop of the car, detain the gear change lever at least on 3 with in neutral position. After that move the lever to position of transfer of a backing.
At switching of the lever from position of 5th transfer to position of 4th transfer, watch to including by mistake the second transfer. Such sharp gear change can cause excessive increase in frequency of rotation of a cranked shaft of the engine (the marksman of a tachometre in a red zone) and can lead to engine damage.


Coupling use

Before transfer inclusion it is necessary to squeeze out completely a coupling pedal, and then slowly it to release. Repeated pressing a coupling pedal is necessary for making only after its reset. Do not hold a foot on a pedal of coupling during car movement. It can lead to deterioration of a disk of coupling. Do not use coupling for car deduction on a bias. For this purpose it is necessary to use a lay brake. Do not suppose sharp and repeating отпускания a coupling pedal.

Receptions of correct driving

Do not slide under a bias on neutral transfer. It is very dangerous. Always hold transfer of the included.

Be not accustomed driving at which it is necessary to brake sharply, and do not hold the left foot on a brake pedal constantly during driving. It conducts to an overheat of brakes and loss of efficiency of their work. On long descents it is necessary to apply braking by the engine to prevention of an overheat of brakes (including hill-climbing gears).

At hill-climbing gear inclusion, slightly brake the car. It will help to prevent excessive increase in frequency of rotation of a cranked shaft of the engine that can lead to its damage.

At a strong lateral wind reduce speed of movement of the car. It will improve its controllability.

Before inclusion of transfer of a backing be convinced, that the car is completely stopped. Otherwise you can damage a transmission. To translate the lever in backing position, at first squeeze out a coupling pedal, translate the lever in neutral position, wait 3 with, and then translate the lever in backing position.

Be especially cautious at movement on slippery road, during braking, acceleration and a gear change. On slippery road, sharp change of speed of the car can lead to loss of coupling of wheels of the car with road and management loss over the car.


The prevention

At control loss over the car on high speeds the risk переворачивания the car considerably increases.
Control loss often occurs, when two or more wheels move down from a road track, and the driver tries to return the car back on road.
In a case if your car has moved down from a road track, avoid sharp turn of a steering wheel. Instead, lower speed of the car before again driving on road.


To take out a key from the ignition lock

PERFORMANCE ORDER
1. Turn the ignition key in position "АСС" ("the Additional equipment").
2. Simultaneously press and turn the ignition key counter-clockwise from position "АСС" ("the Additional equipment") in position "LOCK" ("Blocking").
3. The ignition key can be taken out from the lock only in position "LOCK" ("Blocking").

Recommended speeds for a gear change

For economic driving it is recommended to switch transfers on the speeds specified more low.

Transfer
Recommended speed
With 1st on 2nd or with 2nd on 1st
20 km/h
With 2nd on 3rd or with 3rd on 2nd
40 km/h
With 3rd on 4th or with 4th on 3rd
55 km/h
With 4th on 5th or with 5th on 4th
75 km/h