Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
- 15. A central air
   15.1. Specifications
   15.2. The instruction on coolant application
   15.3. Remarks at replacement of elements of a central air of air
   15.4. Connection of elements of a central air of air
   15.5. Check of elements of the central air established on the car
   15.6. Installation of manometres for pressure measurement
   15.7. Откачка atmospheric air from a central air
   15.8. Gymnastics of a central air of air
   15.9. Check of level of a coolant
   15.10. Check of operational characteristics
   15.11. Oil for greasing of the compressor of the conditioner
   15.12. Relay check
   15.13. The conditioner compressor
   15.14. The plug of coupling and a pulley of the compressor of the conditioner
   15.15. The coil of excitation of coupling
   15.16. Compressor check on the car
   15.17. The gauge of threefold (double) pressure
   15.18. The fan and the condenser
   15.19. The evaporator
   15.20. Check of the thermostatic gauge (термистора)
   15.21. The air filter of the evaporator
   15.22. The heating and ventilation block
   15.23. The heater block
   15.24. The fan
   15.25. Search and elimination of malfunctions
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes







15.15. The coil of excitation of coupling

Removal

PERFORMANCE ORDER
1. Remove the plug of coupling and a pulley of the compressor of the conditioner.
2. Establish the safety tool on an open aperture of a shaft of the compressor.
3. Establish a stripper on the compressor how it is shown in drawing. Establish a tip of the press screw in dredging of the safety tool of a shaft of the compressor and tighten the stripper screw.
4. Tightening a wrench the stripper screw, remove the coil from the forward party of the compressor.

The prevention

Do not use pneumatic tools.



Installation

PERFORMANCE ORDER
1. Clear the coil of excitation of coupling.
2. Establish the compressor vertically, shaft upwards, and establish the coil of excitation of coupling on the forward party of the compressor. Be convinced, that the electric socket of the coil is located correctly.
3. Establish the safety tool on an open aperture of a shaft of the compressor.
4. Establish the tool запрессовки coils on internal radius of the coil of excitation.
5. Tighten a wrench the screw of the tool before coil installation into place.
6. Establish the plug of coupling and a pulley of the compressor of the conditioner.