Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
- 15. A central air
   15.1. Specifications
   15.2. The instruction on coolant application
   15.3. Remarks at replacement of elements of a central air of air
   15.4. Connection of elements of a central air of air
   15.5. Check of elements of the central air established on the car
   15.6. Installation of manometres for pressure measurement
   15.7. Откачка atmospheric air from a central air
   15.8. Gymnastics of a central air of air
   15.9. Check of level of a coolant
   15.10. Check of operational characteristics
   15.11. Oil for greasing of the compressor of the conditioner
   15.12. Relay check
   15.13. The conditioner compressor
   15.14. The plug of coupling and a pulley of the compressor of the conditioner
   15.15. The coil of excitation of coupling
   15.16. Compressor check on the car
   15.17. The gauge of threefold (double) pressure
   15.18. The fan and the condenser
   15.19. The evaporator
   15.20. Check of the thermostatic gauge (термистора)
   15.21. The air filter of the evaporator
   15.22. The heating and ventilation block
   15.23. The heater block
   15.24. The fan
   15.25. Search and elimination of malfunctions
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes







15.9. Check of level of a coolant

PERFORMANCE ORDER
1. Start the engine, leave to work on frequency of rotation of a cranked shaft of 1500 mines-1.
2. Establish switch A/C in position ON.
3. Establish the handle of adjustment of temperature in as much as possible cold position.
4. Establish the handle of management of the fan for the maximum speed.
5. Through 5 mines check up, whether the quantity of a coolant is sufficient with conformity with the following table.

Check point
Quantity of a coolant
It is not enough
There is not enough
Normally
It is too much
Temperature of tubes of high and low pressure It is few difference of temperatures of tubes of high and low pressure Tube on the high pressure party warm, and on the party of low pressure – cold Tube on the high pressure party hot, and on the party of low pressure – cold Tube on the high pressure party too hot
Repair Stop the compressor and spend full check Check up presence of leaks, eliminate them and charge a central air   Tube on the high pressure party too hot